Quartet� Designer Sign Stand
There are NO replacement parts for this product!
The actual metal stand is fine. However, there is a clear folder that fits into the metal to actually hold the sign. That piece is of poor quality, and they do not sell a replacement part (should cost a couple of bucks if they had it.) Since my holder needs replacement, I will have to make one myself. Bummer.
May 19, 2014
Quality control issues with this product
The countersunk hole in the bottom of the base to accommodate the flathead screw for the upright pole is cut too deep, allowing too much of the screw shoulder to protrude out the top of the base, making it impossible to completely tighten the upright pole to the base. We assembled four of these, and all were the same. Poles were wobbly and not very stable.
Also, the first couple of spring plunger screw hole threads were filled with paint, and we had to run a tap through the back side to clean out the threads.
A couple of sloppy quality control errors that caused a lot of grief in assembly.
March 28, 2014
Looks sharp in any lobby
This stand makes any sign look impressive. I only wish the part that hold the sign was more durable or that replacements were offered. The stand is made of sturdy material and will last for years if you are careful not to damage the plastic insert that holds your signage.
May 31, 2013
If you've bought this stand before, think again.
They changed the allowable thickness of media that is able to fit in the stand. Much smaller.
December 13, 2012