Perle S-110PP-S1SC20U - Fiber media converter - 100Mb LAN - 10Base-T, 100Base-TX, 100Base-BX - RJ-45 / SC single-mode - up to 12.4 miles - 1550 (TX) / 1310 (RX) nm

Perle S-110PP-S1SC20U - Fiber media converter - 100Mb LAN - 10Base-T, 100Base-TX, 100Base-BX - RJ-45 / SC single-mode - up to 12.4 miles - 1550 (TX) / 1310 (RX) nm
1 / 1

Description

    • Pause (IEEE 802.3xy). Pause signaling is an IEEE feature that temporarily suspends data transmission between two devices in the event that one of the devices becomes overwhelmed. The media converter supports pause negotiation on the 10/100BASE-TX copper connection.
    • Auto-negotiation (802.3u). The media converter supports auto negotiation on the 10/100BASE-TX interface.
    • Link pass-through. With link pass-through the state of the UTP receiver is passed to the fiber transmitter to make the media converter appear transparent to the end devices that are connected. In addition if Far-End Fault is enabled the media converter can turn off the 10/100BASE-TX transmitter when a FAR-End Fault is received.
    • PD power reset. Ideal for remotely resetting equipment, this configurable function performs a momentary power reset to the attached Powered Device (PD). When enabled, the media converter, upon loss of fiber RX, turn off PSE output power supplied to the PD device for 2 seconds then turn the power back on and leave it on until such time that another fiber RX link is lost (after it was re-established). When disabled, a loss of fiber RX has no effect on PSE power to the PD device(s).
    • Far-End Fault (FEF). The media converter implements the 802.3 standard for Far-End Fault for the indication and detection of remote fault conditions on the 100BASE-X fiber connection. With Far-End Fault enabled the media converter transmits the Far-End Fault indication over the 100BASE-X fiber connection whenever a receive failure is detected on the 100BASE-X fiber connection. The media converter continuously monitors the100BASE-X fiber connection for a valid signal.
    • Auto-MDIX. Auto-MDIX (automatic medium-dependant interface crossover) detects the signaling on the UTP interface to determine the type of cable connected (straight-through or crossover) and automatically configures the connection when enabled. With auto-MDIX enabled, either a straight-through or crossover type cable can be used to connect the media converter to the device on the other end of the cable.